I raised a draft PR (https://github.com/vyos/vyos.vyos/pull/357) to tackle some of the compatibility issues. I will try and finalise it in coming days

forum post with the same problem: https://forum.vyos.io/t/vyos-1-2-traffic-policy-shaper-match-interface-not-working/8389

exmaple test with shaper policy:

Implemented handling for the CLI command to set a filter by interface(rt_iif).
Implemented a command such as set qos policy limiter test class 10 match test_match interface 'eth1' to generate filters similar to those used in VyOS 1.3.

This is not valid for 1.4 and 1.5
Only valid for 1.3 and older images.

Thanks for bringing this to our attention @paulywog

I was able to update my router to VyOS 1.5-rolling-202411070006 and my xen vif interface is working once again. Thanks everyone!

I've just encountered the same issue upgrading from a 1.5 build from May 2024 to the most recent a few days ago. Had very little time to investigate. Next week I'll take some more time and will report back if I find anything interesting.

Hi marekm

Needs testing, will be fixed in the next rolling release

@syncer not it doesn’t
JSON parser wasn’t back ported so other branches are not affected

@Viacheslav, does this require a backport?

Is the binary file data/live-build-config/archives/zabbix-official-repo.key.chroot correct? Other key files there are text files.

BTW @SteveP these iperf speeds look quite impressive, I thought USB overhead would make it difficult to see much more than 1 Gbps in practice. Realtek was traditionally a "low cost, low performance" brand, it seems they have made a lot of progress...

Please make it possible to load the microde separately (file downloaded directly from CPU vendor, independent of VyOS update) to address the last edge case. Especially important for some Intel CPUs that self-destruct with too high voltage, as update applied too late will not reverse any permanent damage already done.

I created a separated bug report https://vyos.dev/T6856

Where does this leave us?

@talmakion tested. everything works.

Ah, does that explain what I commented on earlier?

I'm going to close PR, https://github.com/vyos/vyos-build/pull/832#pullrequestreview-2420618828

I'll let you know.

@paulywog Can you check the latest rolling?

@SteveP Thanks!
I created a PR to exclude these rules https://github.com/vyos/vyos-build/pull/832

It seems to be the 50-usb-realtek-net.rules file causing the strange behaviour.

PR https://github.com/vyos/vyos-1x/pull/4182

We use suricata only for the rolling
backport not required

I believe I am bumping into this issue aswell:

This version has a 6.9.0 section so you would think it would also cover 6.6.x

New version 2.19.2 same problem!

It is not a future-oriented solution to require an old version.
Apart from that, the bug has already been closed in https://github.com/vyos/vyos-documentation/pull/1562 - unfortunately I forgot to close the issue here as well.