@apasheev it were rewritten in https://github.com/vyos/vyos-1x/pull/1567/files#diff-7839502816137d55f673c064e6ec87a2eed7dc80563b1e307363c3e4b090a2b3R302
set policy route-map FOO rule 10 set extcommunity rt '1111:2222222' set policy route-map FOO rule 10 set extcommunity rt '33:444' set policy route-map FOO rule 10 action permit
This would be a great feature to have on VyOS.
PR Equuleus: https://github.com/vyos/vyos-build/pull/368
PR for equulues https://github.com/vyos/vyos-1x/pull/2058
PR for 1.3 https://github.com/vyos/vyos-1x/pull/2057
Actually this uncovered a "bug" that there is no verify() section that validates if the configured interfaces actually have an IP address configured.
if len(config.get('interface', [])) < 2 or len(config.get('interface', [])) > 2:
raise ConfigError('Only two interfaces are required for udp broadcast relay "{instance}"')Yes that works, output successful (see command in bug report).
Could you try with this command to see if the curl output is successful.
Just tested again with 1.3.3. When setting set firewall send-redirects enable, ICMP redirects work fine until I reboot the router.
Before rebooting:
root@vyos:~# sysctl -a | grep send_redirect net.ipv4.conf.all.send_redirects = 1 net.ipv4.conf.default.send_redirects = 0 net.ipv4.conf.eth0.send_redirects = 0 net.ipv4.conf.eth1.send_redirects = 0 net.ipv4.conf.eth2.send_redirects = 0 net.ipv4.conf.eth3.send_redirects = 0 net.ipv4.conf.lo.send_redirects = 0 net.ipv4.conf.wg0.send_redirects = 0
After rebooting:
root@vyos:~# sysctl -a | grep send_redirect net.ipv4.conf.all.send_redirects = 0 net.ipv4.conf.default.send_redirects = 0 net.ipv4.conf.eth0.send_redirects = 0 net.ipv4.conf.eth1.send_redirects = 0 net.ipv4.conf.eth2.send_redirects = 0 net.ipv4.conf.eth3.send_redirects = 0 net.ipv4.conf.lo.send_redirects = 1 net.ipv4.conf.wg0.send_redirects = 0
There is the similar task https://vyos.dev/T1518
This problem still exist on VyOS 1.4-rolling-202306070317