The working implementation is linked below; performance is not yet comparable to the legacy loadFile, though there are obvious points of optimization to be made. The general framework will be submitted for PR to support other development, with load_config as an illustrative example, but not yet a replacement for loadFile.

Feb 1 2024, 3:41 AM · VyOS Rolling

Jan 31 2024

yzguy added a comment to T5965: WWAN modems using raw-ip do not work with dhclient/dhcp6c.

New data point. I installed vanilla Debian 12, connected modem via

Jan 31 2024, 10:20 PM · VyOS 1.4 Sagitta (1.4.0-epa1), VyOS 1.5 Circinus

fernando added a comment to T5997: Support SSL backends in reverse proxy.

it think that we can use also something similar to what we use ocserv to generate ssl certificates:

Jan 31 2024, 6:10 PM · VyOS Rolling

jestabro moved T6000: [1.3.x -> 1.5.x] migrating threw exception in /opt/vyatta/etc/config-migrate/migrate/https/5-to-6, performed workaround from Open to Finished on the VyOS 1.4 Sagitta board.

Jan 31 2024, 5:46 PM · VyOS 1.4 Sagitta, VyOS 1.5 Circinus

jestabro closed T6000: [1.3.x -> 1.5.x] migrating threw exception in /opt/vyatta/etc/config-migrate/migrate/https/5-to-6, performed workaround, a subtask of T5886: Add support for ACME protocol (LetsEncrypt), as Resolved.

Jan 31 2024, 5:46 PM · VyOS 1.5 Circinus, VyOS 1.4 Sagitta

jestabro closed T6000: [1.3.x -> 1.5.x] migrating threw exception in /opt/vyatta/etc/config-migrate/migrate/https/5-to-6, performed workaround as Resolved.

Jan 31 2024, 5:46 PM · VyOS 1.4 Sagitta, VyOS 1.5 Circinus

Viacheslav moved T5999: load-balancing reverse-proxy can't configure root as a redirect from Open to Finished on the VyOS 1.4 Sagitta board.

Jan 31 2024, 9:09 AM · VyOS 1.4 Sagitta, VyOS 1.5 Circinus

Viacheslav closed T5999: load-balancing reverse-proxy can't configure root as a redirect as Resolved.

Jan 31 2024, 9:09 AM · VyOS 1.4 Sagitta, VyOS 1.5 Circinus

cleopold73 added a comment to T5999: load-balancing reverse-proxy can't configure root as a redirect.

I put together a PR for this https://github.com/vyos/vyos-1x/pull/2908. I just edited this in github, I was kind of hoping that a workflow would run the smoketests, but I'm not sure that is the case. Either way I'll try pulling the code local and see what I can figure out.

Jan 31 2024, 4:24 AM · VyOS 1.4 Sagitta, VyOS 1.5 Circinus

Jan 30 2024

cleopold73 added a comment to T5997: Support SSL backends in reverse proxy.

Maybe something like

Jan 30 2024, 11:41 PM · VyOS Rolling

yzguy added a comment to T5965: WWAN modems using raw-ip do not work with dhclient/dhcp6c.

Seemingly long term solution is to migrate to a DHCP/DHCPv6 server that supports it. I've been going back and forth with the systemd folks -- https://github.com/systemd/systemd/issues/27219
One of them seems to show it works fine, but I can't replicate it. I am going to try and do it under just normal Debian 12 bookwork and not VyOS so as not to introduce anything strange

Jan 30 2024, 9:15 PM · VyOS 1.4 Sagitta (1.4.0-epa1), VyOS 1.5 Circinus

syncer assigned T5995: Kernel NIC-drivers for Huawei NICs are not properly enabled to c-po.

Jan 30 2024, 9:13 PM · VyOS 1.4 Sagitta, VyOS 1.5 Circinus

c-po claimed T6005: Error on adding a wireguard interface to OSPFv3.

Jan 30 2024, 8:45 PM · VyOS 1.4 Sagitta (1.4.0-epa1), VyOS 1.5 Circinus

Spookje added a comment to T6005: Error on adding a wireguard interface to OSPFv3.

Some update in the time i posted it on the forum and posted it here,
today i added an additional IPSec-VTI VPN with OSPF (IPv4),
all working as expected.

Jan 30 2024, 8:30 PM · VyOS 1.4 Sagitta (1.4.0-epa1), VyOS 1.5 Circinus

Spookje created T6005: Error on adding a wireguard interface to OSPFv3.

Jan 30 2024, 8:23 PM · VyOS 1.4 Sagitta (1.4.0-epa1), VyOS 1.5 Circinus

c-po changed the status of T5967: Multi-hop BFD connections can't be established; please add minimum-ttl option. from Resolved to Unknown Status.

Jan 30 2024, 8:09 PM · VyOS 1.3 Equuleus (1.3.6), VyOS 1.5 Circinus, VyOS 1.4 Sagitta

fernando added a comment to T5930: vrf - route-leak not work using route-target both command..

it makes seens , agree with add a Config Error to do not allow both options simultaneously ,.

Jan 30 2024, 6:21 PM · VyOS 1.5 Circinus, VyOS 1.4 Sagitta

dmbaturin triaged T5995: Kernel NIC-drivers for Huawei NICs are not properly enabled as High priority.

Jan 30 2024, 5:07 PM · VyOS 1.4 Sagitta, VyOS 1.5 Circinus

a.apostoliuk added a comment to T5930: vrf - route-leak not work using route-target both command..

In this case, 'both'' is preferred now.
If you use in frr