What would be the "full set" up supported characters? If I remember correctly this regex is inherited from VyOS 1.1

Please share your Cisco and VyOS config, and also the Cisco router Model/Version

For RPS, we maybe can adapt https://github.com/bhuanand/rps-rfs-configuration to VyOS?

When using show pki ... commands you would be able to see the relation between certificates and CAs.

THis is infact only relevant when IPv6 addressing is used.

PR: https://github.com/vyos/vyos-1x/pull/899

I ver much like this idea. Certificates can then easily be migrated from device to device, and very easy be referenced in a service.

Sorry, this may be my fault. It seems that I only pay attention to modifying the identifier below and forget the top definition. Sorry.

PR https://github.com/vyos/vyos-1x/pull/898

@Dmitry Is it an actual task? Code was rewritten.

Already fixed with "no_tag_node_value_mangle=True"
https://github.com/vyos/vyos-1x/blob/705eddbc7a2caf09c37ecafb27418a764217975a/python/vyos/config.py#L218

Eigrp in the FRR doesn't work correctly.
The routes still live even if neighbors in a shutdown state.

@Cheeze_It can you re-check it?

There is a link to the existing code for configuration mode, not pr.
So we can to add the op-mode function to re-add/reset with a similar logic. Only thoughts

Not working for me as expected in 1.3.0-rc4
In my current working configuration, the duid is in the /var/lib/dhcpv6/dhcp6c_duid file (29 bytes).

In T3640#96973, @Viacheslav wrote:

I think it will be enough to remove the peer and add again.
@hagbard what do you think?
https://github.com/vyos/vyos-1x/blob/d48dddab0509e562209adfb115b0e691b8e47f54/python/vyos/ifconfig/wireguard.py#L197

Not sure about double quotes, but for example for cloud-init configs, it is necessary to use single quotes.
Ideally, the configuration should look like in show configuration commands

I think it will be enough to remove the peer and add again.
@hagbard what do you think?
https://github.com/vyos/vyos-1x/blob/d48dddab0509e562209adfb115b0e691b8e47f54/python/vyos/ifconfig/wireguard.py#L197

PR https://github.com/vyos/vyos-1x/pull/897
Fix path for swanctl.conf file

In T3640#96937, @hagbard wrote:

Wireguard has no link states on the interface, the ip command just does an 'administrative' up down, which won't start a renegotiation. The policy description (remove peer) needs to be removed from the wg interface and re-added, otherwise you need to wait until wg tries to rekey which will then eventually renegotiate the entire connection.
The removal was as far as I recall part of the original vyos code, so it may have been removed at one point, I haven't looked into the code yet.

For NAT, try setting persistent-keepalive, that is supposed to keep the NAT entry active, even if you have no traffic for the tunnel.

@Harliff Try 1.2.7/1.3 it was fixed with commit https://github.com/vyos/vyos-build/pull/138/files#diff-c7d29a506307d9cf8d86c3cd3f65ca4e4058ea442cacdf9a89d2485b56c7417aR67
T2061