I ve tested it:

This situation is worst, since ipset exposed the error, but vyos cli accepts it, and remains in the running configuration:

1.3 PR: https://github.com/vyos/vyatta-cfg-system/pull/176
1.4 PR: https://github.com/vyos/vyatta-cfg-system/pull/177

@n.fort I have been able to reproduce this, it only occurs when installing for UEFI.

this issue with frr.reload.py keeps happening with stable/8.1 , we'll try it when 8.2 is stable.

Hey @n.fort yes I did test it per my comment on Jan 23rd. It's fine just different in that type used to be a name and now it's an integer with a separate option of type-name. It's fine was just noting the difference compared to previous versions.
Thanks for checking!

Tested on VyOS 1.4-rolling-202202150317:

I can't add anything else unfortunately, it just doesn't work for me on a physical device whichever value I enter, it always takes the remainder of the free space for the root partition. Manually modifying it works fine.

I think this task can be marked as resolved, but before doing that, anything else @artooro ? Were you able to test it?

Reopen to add some simplifications to the interface, inspired by T4260.

@pvanberlo Can you share more info on how we can reproduce this issue?

I wasn't able to reproduce the issue.
I installed 3 times VyOS 1.3.0 version on Proxmox:

If VyOS goes for Kea, it might be a better idea to invest time in Kea DHCPv6, as it has hook libraries which might resolve this task neater.

Confirm successful sending of syslog messages with NAT broadcasts. It is not information about every packet that is sent, it is information about the entry in the conntrack table. Therefore it takes some time before the syslog messages are visible.

PR: https://github.com/vyos/vyatta-cfg-qos/pull/12

Adding priority >=615 should fix it

vyos@r11-roll# sudo cat /opt/vyatta/share/vyatta-cfg/templates/interfaces/ethernet/node.tag/vif/node.tag/redirect/node.def
type: txt
priority: 615
help: Incoming packet redirection destination
allowed: /opt/vyatta/sbin/vyatta-interfaces.pl --show=input

Explanation on how to reproduce this error:

• On fresh install on 1.2.8 (more parameter may be needed to be able to upgrade router):

set interfaces input ifb042
set interfaces ethernet eth0 vif 42 address 203.0.113.47/32
set interfaces ethernet eth0 vif 42 redirect 'ifb042'

Then add and install 1.3.0 vyos image, and reboot.

VyOS 1.4

set interfaces input ifb042
set interfaces ethernet eth0 vif 42 address 203.0.113.47/32
set interfaces ethernet eth0 vif 42 redirect 'ifb042'

Same problem when downgrading from 1.3.0 to 1.2.8

Can confirm the problem.
Also, when bootting on 1.3.0 version, and trying to load pre-migration config file, it's also not possible.
Removing "redirect" entry from pre-migration file, configurations loads correctly.
Once configuration was loaded, "redirect" command con be inserted once again in cli, and it is accepted.

@Cheeze_It It is not hard https://github.com/vyos/vyos-1x/blob/current/op-mode-definitions/show-bgp.xml.in

@Viacheslav, hmmm, yeah that's a good point. I'll see what I can do to add the OP configs. I know I added the conf configs.

@Cheeze_It There is a task for op-mode T4265
Task for controller T4266