Page MenuHomeVyOS Platform

show arp interface <interface> does not work
Closed, ResolvedPublicBUG


[email protected]:~$ show arp interface eth1.1728
arp: in 16 entries no match found.
[email protected]:~$ show arp | grep eth1.1728           ether   b8:af:67:7c:a2:b7   C                     eth1.1728
[email protected]:~$ show version 
Version:          VyOS 1.2.2

Expected output:
Expected to see output from that specific interface.


Difficulty level
Unknown (require assessment)
Why the issue appeared?
Will be filled on close

Event Timeline

Hello @olofl , I think you need show protocols static arp interface eth1.1728 command. You also may read about ARP on

@Dmitry, thanks for reply.

I suppose you mean to run that command in configure# mode? If thats the case, this is not a static arp entry, its a dynamic one.

And the ~$ show protocols static arp or ~$ show protocols <> commands doesn't exist under normal display mode.

[email protected]:~$ show protocols

  Invalid command: show [protocols]

Yes, sorry, I was mean about new syntax for rolling release. PR for fixing issue with ARP

syncer triaged this task as Normal priority.
syncer moved this task from Need Triage to Finished on the VyOS 1.3 Equuleus board.
syncer moved this task from Finished to Backlog on the VyOS 1.3 Equuleus board.